Learn how to put your Star SP700 printer into Epson mode using the printer's dip switches.
Introduction
The Star SP700, by default, comes set to use its native Star mode for printing. If directed by support, you can set it for Epson mode using the hardware's dip switches.
Setting Up the Printer
- Turn off the power to the printer and unplug it.
- Flip it upside down.
- Unscrew the panel on the bottom. (This will require a Phillips head screwdriver.) The panel is typically screwed on very tightly by the factory and can take some effort to unscrew. It is very important you have the right-sized screwdriver to prevent damaging the screw head when applying effort.
Note: The dipswitch panel is smaller than it might appear in these photos. It's also important to orient your printer as illustrated above (the front of the printer to your right and the rear with the power/Ethernet ports to the left).
- Your printer dip switches will initially be set for "Star Mode" (pictured above).
- Push Dip Switch # 4 in the opposite position in line with #2 and #8. (Note: Dip Switch # 2, # 4, and # 8 should all be in the opposite direction of the other switches.)
- Screw the cover back on.
- If you unplugged the printer, plug the power cables back in. Do not turn the printer on yet.
- Connect the Ethernet cable to the back of the printer (insert it into the Ethernet port) and then plug it into one of the available Ethernet ports on your router or switch.